Specs
Router Bit Set specs
Setup notes and briefing numbers for Router Bit Set.
Included cutters and shank sizes
Bit sizes, profiles and coating details included in the set are listed here. Make sure the selection fits your router, collet and usual material range.
The Router Bit Set includes cutter diameters, profile types and the rainbow coating used on each bit. Check every shank size against your router collet before ordering, especially if your shop alternates between trim routers and full-size spindle setups. MDF, plywood, solid pine and plastics do not place the same load on the edge, so the listed geometry matters.
Before the first cut, confirm the bit length below the collet, the nut clearance and the available plunge on your machine. A short setup note beside the router helps when operators swap from straight bits to round-over or V-groove profiles during the day. That small check prevents collet slip, burnt edges and chatter marks on sheet material.
Profiles listed in the set
Expect the page to identify the working profile of each cutter, such as straight, flush trim, chamfer, round-over or V-bit, together with the matching diameter. Those details decide whether the set suits cabinet parts, sign work, edge finishing or general trimming. One mixed set can cover several common jobs, but only if the profile sequence matches what your router table or handheld machine actually does.
Compare cutting diameter, shank size and coating before adding the set to a job card or parts list. If you need clarity on compatibility, use the contact form and include the router model, collet size and the material you cut most often. It also helps to note whether the set will run on a table router, CNC spindle or handheld unit.
- Shank sizes matched to collets
- Profile details for edging work
- Coating notes for cutter care
Workshop checks for South African conditions
Heat, dust and storage conditions in Gauteng, Durban and Cape Town all affect router bit life in different ways. Inland shops often deal with fine MDF dust packing into collets, while coastal air calls for stricter wipe-down and dry storage after use. Judge the specs against the timber, board stock and plastics you usually cut, not in isolation.
Power interruptions make restart checks more important when a bit set is shared across machines on the same shift. After a stop, inspect the cutting edge, tighten the collet again and verify the projection before resuming. On laminated boards, even a slight movement can show immediately as top-face chip-out.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Set-up notes before first run
Measure your collet first, then compare it with every shank size shown for the Router Bit Set specs page. If a cutter is intended for decorative edging, note the bearing size and the finished radius before you take it to the workpiece. That saves test pieces when matching an existing panel or trim detail.
Keep a record of spindle speed, feed rate and material for the first sample cut made with each profile in the set. Those notes are useful when the same bit moves from melamine board to hardwood or acrylic. A simple sheet near the machine is often enough to stop guesswork on the next run.
What our CNC Tooling customers say
Verified Google reviews