Specs
Plate Cell specs
Setup notes and briefing numbers for Plate Cell.
Plate dimensions and cutter fit
Plate Cell specs lists the key measurements and tooling details for CNC plate work. Check diameters, coating options and application notes here before choosing cutters for aluminium, composites or similar sheet stock.
Use this Plate Cell sheet to confirm plate thickness, cutter diameter and hold-down before a sheet goes on the bed. Aluminium plate, ACM and composite panels do not react the same once spindle speed and chip load move off target. Johannesburg dust, Durban humidity and Cape Town salt air also change how often collets, toolholders and stored bits need inspection.
Check the first setup against these figures before running a full nest. A quick photo of edge finish, tab position and burr level is useful when matching later batches. Keep the note near the controller so the operator can verify offsets, clamp clearance and tool stick-out without hunting through old files.
Numbers to confirm before cutting
These measurements affect cut quality on plate work. Confirm flute count, coating option, shank size and recommended material use against the job card. If a cutter is marked for aluminium, check evacuation and lubrication details before sending it into composite sheet or coated panel.
Read Plate Cell specs alongside the matching cell notes when changing from one sheet material to another.
- Plate thickness matched to cutter reach
- Burr check on first edge pass
Workshop checks for SA conditions
Plate jobs in Gauteng often need closer dust control around vacuum zones and linear rails. Coastal shops should watch storage on coated tooling, especially when packs are opened and left near humid air. If sheets arrive from a different supplier lot, recheck thickness and flatness before reusing old offsets.
Power interruptions can leave a plate job mid-sheet, so record restart position and tool wear before stopping the machine. Imported aluminium and locally stocked composite board may cut differently even at the same nominal size. For showroom samples, use the same cutter and feed approach planned for production so the finish tells the truth.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
What to send with Plate Cell
Include plate material, nominal thickness, finished edge requirement and any coating preference on the bit. Add photos of hold-down, spoilboard condition and the current cutter if edge breakout or chatter has shown up. Mention whether the work is aluminium, composite or another sheet product so the specs can be checked against the right use case.
File this spec sheet with the job note, cutter code and machine settings used on the successful run. That record helps when a buyer asks for the tooling reference or when the same plate profile comes back months later. Mark any changes to diameter, stick-out or coating so the next setup starts from the correct version.
What our CNC Tooling customers say
Verified Google reviews