Specs

Engraving Bit specs

Setup notes and briefing numbers for Engraving Bit.

V-point sizes and cutting angles

Engraving Bit sizes, profile details, and the checks needed before running fine work are listed here. Choose the right bit for the finish and detail level required.

Engraving Bit specs focus on tip geometry, flute length, shank size, and the material each cutter is suited to. Fine text in acrylic, light linework in aluminium, and board marking on MDF do not use the same included angle or depth target. A small change in tip width can alter edge sharpness, burr formation, and how cleanly the detail reads after the pass.

Before running a detailed job, check collet grip, spindle runout, and whether the bit seats fully without dust packed in the taper. On small engraving tools, even slight vibration can chip the point or leave uneven stroke width across the panel. Keep the setup note close to the machine so the operator can confirm zeroing, depth, and feed entry before the first sample.

What the specs page covers

This sheet sets out the dimensions and pre-run checks used when selecting an Engraving Bit for fine CNC work. It is there to help match the cutter to letter height, groove profile, substrate hardness, and the finish expected on the face. For rainbow-coated tooling, the coating is part of the selection, but the point angle and usable cutting length still drive the result.

Use these specs alongside the machine programme and material sheet before loading a new cutter into the spindle. If anything in the setup differs from the listed bit size, confirm the path, clamp clearance, and Z reference before cutting. For questions sent through the contact form, include the bit code, material type, and the profile you are trying to achieve.

Tip angle matched to line detail
Shank, flute, and depth checks
Setup notes for fine-cut verification

Workshop conditions across South Africa

Dry inland dust around Gauteng workshops can build up in collets and around vacuum shoes, which matters when using narrow engraving points. Coastal humidity in Durban and Cape Town calls for better storage habits so tooling does not sit with surface corrosion or contamination before use. These conditions affect cut quality long before the file itself is the problem.

Load-shedding recovery checks are worth doing before restarting a detailed engraving run, especially where the cutter returns to very fine lettering or logos. Confirm home position, spindle warm-up, and workholding after any interruption. On softer plastics, heat build-up can also show faster during slower restarts, so feed and spindle settings must stay aligned to the bit geometry.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Checks before fine engraving

Measure the cutter point under magnification if the job depends on narrow strokes or repeatable corner detail. A worn tip can make characters appear heavier than the programmed path and can close up small gaps in decorative work. Record the actual measured point if the design tolerance is tight.

Run a short test on the same material where possible, using the planned depth and feed settings from the production file. Look for burrs, frayed fibres, chip welding, or a widened groove at entry points. Those signs usually tell you whether the Engraving Bit, spindle speed, or hold-down needs adjustment before the final panel goes on the bed.

What our CNC Tooling customers say

Verified Google reviews