Support
Training Hour
Training Hour is for teams who keep seeing the same cutter damage, poor edge finish, or setup errors during CNC work. It gives operators, setters, and supervisors one focused session around handling, feeds, collets, and machine habits that affect tool life.
How training hour covers rainbow-coated bit handling
Training Hour covers practical CNC topics for operators, setters, and workshop staff working with cutters, collets, feeds, and machine handling. Use it when the issue is not one broken part, but repeated mistakes on the floor.
Bring the board type, cutter spec, spindle details, and the problem seen on the machine. MDF, plywood, solid timber, plastics, and aluminium each need different chip load checks, hold-down methods, and cleaning routines. South African workshop conditions such as dust build-up, voltage interruptions, and mixed machine ages should be part of the brief.
Clear photos of the spindle area, tool holder, spoilboard, and failed parts help shape the session properly. Include the machine model, control type, and what operators are doing just before the fault shows up. A short printed note near the machine can then match the exact training point covered.
Skills covered in session
Training Hour can centre on one repeated issue such as chipped compression bits, burnt cuts, loose collets, or poor sheet nesting discipline. The outcome is a tighter operating routine with named checks for tool fitting, run order, feed settings, and part inspection. Written notes should use the same cutter and machine terms the team sees every day.
If the problem links to tooling choice, mention the bit in use and the wear pattern showing on it. Add machine details through the contact form so the session can stay on the error your machine is showing. Where useful, include the last setup note, feed and speed values, and one image of the current tool assembly as fitted.
- Collet fit and clamping checks
- Feed, speed, and entry review
- Site photos included with brief
Workshop factors that matter
Gauteng dust, coastal moisture, and mixed fleet machines change how training should be pitched. Older routers may need extra focus on spindle cleanliness, backlash signs, and warm-up habits before a production run. Busy shops also need guidance that fits around shift handovers and current job priorities.
Humidity near the coast can affect cutter storage, rust spots, and how collets are maintained between runs. Inland workshops often fight fine dust around rails, extraction points, and tool holders, which can lead to poor seating and runout issues. Load-shedding plans should also be discussed where interrupted cuts are damaging parts or bits.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
What to send beforehand
Send the training brief with site photos, machine details, timing, and the skill gap you want covered. Keep the subject line plain.
Include the material being cut, the cutter type, and whether the issue appears at entry, during the pass, or on the final edge. That makes the Training Hour easier to focus on one repeat problem instead of a wide list of guesses.